可堆叠电线架及线轴 Stackable wire racks and spools

这是一个简单的线缆收纳架和线缆轴，每层收纳架上可以放置5个配套的线缆轴，也可直接使用ok线的线轴

线轴和收纳架均切割成两部分，需要用胶水黏贴。

注意，由于线口的设计，线缆最大不能大于1.9mm

注意，由于层间距的设计，不建议将每层粘在一起，否则可能存在无法放入取出线轴的情况。

This is a simple cable storage rack and cable shaft. Each storage rack can hold 5 matching cable shafts, or you can directly use OK wire spools

The spool and storage rack are cut into two parts and need to be glued together.

Note that due to the design of the cable port, the maximum cable size cannot exceed 1.9mm

Note that due to the design of interlayer spacing, it is not recommended to stick each layer together, otherwise there may be situations where it is impossible to insert and remove the spool.

（machine translation）