朋友让我帮他做个独一无二的漂亮的烟盒,由于圣诞将近,就做了这个圣诞主题的红白色系烟盒,刚做完还没来得及给她,先在此也分享给大家😄。打印前请看完以下说明
A friend asked me to make a unique and beautiful cigarette case for him. Since Christmas is approaching, I made this Christmas-themed red-and-white cigarette case. I haven’t had a chance to give it to she right after finishing it, so I’m sharing it with everyone here first. 😄Please read the instructions below before printing
切片注意:烟盒翻盖上的文字可自己更改为自己喜欢的任何文字。改字步骤看图:
Slicing Note: You can freely change the text on the cigarette case flip to any text you like. Steps for character correction as shown in the image:
![]()
打印注意:PLA、PETG均可,建议PLA或PLA slik打印出来效果更美观,清洁热床打印板。
Printing Notes: Both PLA and PETG are acceptable. PLA or PLA silk is recommended for a better visual finish. Clean the heated build plate before printing.
安装注意:铰链处插入耗材丝即可,若松动可两端用打火机加热后按下。铰链位置见图:
Installation Notes: Insert the consumable filament at the hinge. If it becomes loose, heat both ends with a lighter and press down.See the figure for the hinge position:

祝大家开心Wish everyone happiness
