废料盘卷线器

废旧料盘改造卷线器：变废为宝的 “线材收纳神器”这款卷线器是 “变废为宝” 的实用创意 —— 用闲置的 3D 打印废旧料盘组装而成，让原本闲置的料盘焕发新价值。

它的结构适配常见料盘尺寸，组装后可轻松收纳各类线材：无论是充电线、电缆，还是长插线排，都能整齐缠绕在料盘上，告别线材杂乱缠绕的烦恼。自带的手柄设计让收放线更顺手，底部支架则能让卷线器稳定放置在桌面或角落，既是对废旧料盘的环保利用，又能解决家居 / 工作室的线材收纳难题，是省钱又实用的 “环保收纳小能手”。

Transforming waste material trays into wire spoolers: a "wire storage wonder" that turns trash into treasure. This wire spooler is a practical and creative idea that turns waste into treasure - assembled from unused 3D printed waste material trays, giving these otherwise idle trays new value.

Its structure is compatible with common tray sizes, and after assembly, it can easily store various types of cables: whether it's charging cables, power cables, or long extension cords, they can all be neatly wound around the tray, eliminating the hassle of messy cables. The built-in handle design makes it easier to store and retrieve cables, while the bottom stand allows the cable reel to be stably placed on a table or in a corner. It is not only an environmentally friendly use of waste trays but also solves the cable storage problem in homes/studios. It is a cost-effective and practical "little green storage expert".

Installation steps:

First, assemble the base of the wire coil with the wire coil itself. Note that the handle needs to be clipped onto the base at this point.

Align the cover plate and press the other end of the handle into the hole of the cover plate.

Install the fixing screws.

Install the crank into the central hole and flip it over.

When installing the fixed cover plate, a gap should be reserved between it and the base to avoid getting stuck, as this would make it difficult to rotate.

Install the crank handle, and the installation is complete.

安装步骤：

首先将线盘底座和线盘组装起来。注意提手这时就需要先卡住在底座上。

将盖板对其，提手另外一段压入盖板孔洞内。

安装固定螺丝。

将曲柄安装进中间孔洞，并翻面。

装上固定盖板，需要和底座有间隙预留，不能卡死否则会难以转动。

安装上曲柄把手，安装完毕。