焊锡卷轴支架

This is a solder spool holder for 200g - 250g spools with 20mm spindle diameter.

It is specifically designed to fit the Loctite/Multicore 250g rolls, but fits lots of other brands as well.

There are 2 versions with and without a guide/holder for the loose solder wire.

Required hardware

With Guide: 3 x Counter sunk M3 x 12-16mm machine or self tapping screws

Without guide: 2 x Counter sunk M3 x 12-16mm machine or self tapping screws

For consistent finish print the 2 sides with the outside surface on the bed, no supports required.