(Super) Multi-Square Fidget

I made this (Super) Multi-Square Fidget as a print-in-place toy that joins four square super fidgets into one larger piece. It twists and folds in your hands, and the repeating square pattern is what makes it fun to pick up again and again. The part I like most is how it pops in color. I really recommend printing with engaging and bright colors so the print really stands out.

Print settings:

• Infill: 2%-15%
• Infill Type: Gyroid
• Supports: NO
• Brim: NO
• Filament: PLA or PETG or ABS/ASA
• Listed profile: 1 plate in 2 hours 49 minutes 2 seconds, using 65.26 g of PLA, with a slower first layer speed for better results.

Tips:

• The catch is the first layer: if you are having problems, clean the print bed and check the first layer, because it is the most crucial layer in the print.
• The whole print is just perimeters.

My Patreon page is still available at patreon.com/MasterPrinter, but I do not actively update it anymore.

You may also like:

• Square Super-Fidget (Print-In-Place) https://www.makeronline.com/en/model/Square%20Super-Fidget%20(Print-In-Place)/158453.html
• Triangle Super Fidget https://www.makeronline.com/en/model/Triangle%20Super%20Fidget/167631.html
• Tri-Hexagon Super Fidget (Print-In-Place) https://www.makeronline.com/en/model/Tri-Hexagon%20Super%20Fidget%20(Print-In-Place)/167960.html
• Hexa-Triangle Super Fidget https://www.makeronline.com/en/model/Hexa-Triangle%20Super%20Fidget/170413.html
• Gyroscopic Fidget Ring (2 in 1 Fidget) https://www.makeronline.com/en/model/Gyroscopic%20Fidget%20Ring%20(2%20in%201%20Fidget)/185527.html