120 mm Fan Mount w/ speed adjustment

Design Concept

Use a standard 120 mm fan with a fan controller, switch, and 12 V DC power supply. Use for all your fan needs.

Purpose

Use with a carbon filter to purify soldering fumes, put it next to you on the table for a table fan, fan your fans. Fans do fan stuff.

Printing Recommendations

Any filament works.

Assembly Instructions

Screw the fan into the mount. Connect on off switch to the positive wire. Use any power supply that delivers 12 V, I used one with a 5.5 mm x 2.5 mm barrel jack (for this you also need a breakout board or a jack or something like that to solder the wires to + and -). Connect positive wire to fan controller +, negative to fan controller -, and the fan 4 pin connector to the fan controller. Test and cram all of the wires and mess into the convenient box on the sides. Seal it forever, never let anyone see the mess you made with the cables. 

External components I used, use the same, use different, not affiliated or sponsored (AliExpress, pls make it happen): 

12 V DC power supply ->

https://www.aliexpress.com/item/1005005815301733.html?spm=a2g0o.order_list.order_list_main.154.770c18023qzYJR

Switch ->

https://www.aliexpress.com/item/1005008778176373.html?spm=a2g0o.order_list.order_list_main.124.770c18023qzYJR

DC power connector ->

https://www.aliexpress.com/item/1005007077709964.html?spm=a2g0o.order_list.order_list_main.130.770c18023qzYJR

Fan controller ->

https://www.aliexpress.com/item/1005007378748976.html?spm=a2g0o.order_list.order_list_main.118.770c18023qzYJR

(Sorry for the horrible hot gluing, the fan rubber feet got lost and I improvised..)

Thank you for all the support! If you like this model, check out the other designs I’ve created on my profile.

You can also buy me a virtual coffee to help fuel my filament addiction: buymeacoffee.com/ApuPrints.

Find all my socials here: linktr.ee/apuprintsolutions