4 Tier Storage Bins

4 Tier storage bins with dividers

I designed these bins because I had a lot of loose items I use for printing.

The bins were designed with single double and triple dividers. they don't have to be used.

The function of the shelves can be seen in the video I uploaded.

There are two available ways to use it. workbench or wall mounted.

If you choose the workbench model, you can use 4 10mm magnets on the bottom bin and the lower cross member.

Also, you will need to glue the cross members to the uprights

When you choose the wall mount the 4 screws and anchors will hold everything in place.

To hold the bins on the uprights, use a piece of filament at the top of each upright a hole is already provide on each upright of the model.

NOTE:

Please use the print profile I provided as I have the setting set. I performed multiple tests to get the strength and best quality print.

there are 3 print profiles:

1 All bins and joints

2 Workbench uprights

3 Wall mount Uprights

There are four connectors that are used. Two different sizes the thicker connector goes in the back smaller for the sides.

When printing the wall mount profile, I put two removable pieces per mount to cut down on supports.

To remove both pieces, use a utility knife or a small flat head screwdriver to break the sides lose before removing.

When assembling the side joints to the bins just snap them into place no glue or fasteners required.

Printed on the Kobra X

Happy Printing!!!!!!