Abstract 5

Project: Abstract 5.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 200x200mm in size. You can change X and Y but Z must remain the same.

 You may print at higher layer heights below the Min Depth of 0.48mm

 Actual Depth is 2.3mm

Filaments Used:

PLA BambuLab Black Transmission Distance: 0.3

PLA BambuLab Basic Jade White Transmission Distance: 5

PLA BambuLab Basic Red Transmission Distance: 4

PLA BambuLab Basic Orange Transmission Distance: 7

PLA BambuLab Basic Yellow Transmission Distance: 6

This print uses 5 unique filaments. Substitute as needed.

Swap Instructions:

Start with Black

At layer #8 (0.72mm) swap to Jade White

At layer #15 (1.28mm) swap to Red

At layer #20 (1.68mm) swap to Orange

At layer #23 (1.92mm) swap to Yellow

At layer #25 (2.08mm) swap to Jade White for the rest.