All in one test for FDM 3D printer

Test for 3D printers including overhangs, quality, precision, bridging, stringing and thin walls.

• I printed this test with Anycubic Basic PLA on my Kobra 2 pro and it came out pretty good.

• The dimensions of the cube on the test should be 10x10mm. In my case, it was 9.9x9.9mm.

• In the upper left corner is the stringing test. It turned out perfectly on my printer.

• To the right of the stringing test is the nozzle accuracy test. It's constructed of small columns measuring 0.4x0.4mm, making it suitable only for printing with a 0.4mm or smaller nozzle, although the entire test is designed for a 0.4mm nozzle.

• On the back of the test is the bridging test. It has three levels. The first, lowest, has an bride of 18mm. The second, medium, is 22mm long. And the third, highest, is 27mm long.

• At the front of the bridging test is the thin walls test. It has seven different difficulty levels, from 2mm wide to 0.5mm.

• In the lower right corner are two overhang tests. The higher one measures angle accuracy from 20° to 60°. The second, smaller one, measures a constant angle of 27°.

• In the lower left corner is the sharp corners test. The taller square pyramid is 9mm tall, while the smaller one is 6.5mm tall.

• The entire test is 50x50mm.

Thanks for printing!