Anycubic Kobra S1 Improved Settings For Speed And Quality

This is just an improved Printer Profile and Print Settings for the Kobra S1 that increases printing speeds significantly, while not loosing out on quality. I have increased the max speeds for the motion limits of the printer as well as the acceleration speeds and jerk. The speeds, accelerations, and jerks in the print settings have been changed as well.

If you would like to save the settings to your slicer, open the 3mf file in your slicer, click the save icon next to the Printer and Print settings profile names, and check "User Preset". If the slicer does not let you save it (most likely) try renaming the profile and try and save again.

Disclaimer: while these setting work for my machine, every printer is different and I am not liable for any damage that may be caused by using the included profile(s). Use at your own risk. I am using an un-modified (stock) Anycubic Kobra S1C (combo).

The model used: 20mm Calibration Cube by Termixx3D on Thingiverse: https://www.thingiverse.com/thing:5819285 (This thing was created by Thingiverse user Termixx3D, and is licensed under Creative Commons - Attribution) No changes to the model were made.