Anycubic S1 filament purge cutter holder

This is a updated model that alleviates 2 key issues in the previous referenced model:

1. Avoids the purged filament bundle from sticking to the top ledges of the holder
2. Avoids the metal cutter holder from being pushed upwards by the lever swing after the purged filament (poop) is expelled.

It stops the annoying issue of the original metal cutter held by sticky tape dropping out, or issues in some earlier versions where the purged filament bundle tends to get stuck to the printed holder ledges, or the holder gets pushed upwards by the lever arm of the waste chute "spoon".

Printed at 0.16 mm layer height, but other layers heights should work too. Hope this works well for your printer too.