Anycubic i3 Mega-S Extruder Filament Guide (cone)

Not sure if this will be useful to anyone. It's the little cone thing that is part of the extruder that comes with the Anycubic i3 Mega-S. I lost mine for awhile, and made this replacement. When I tried to pull it out after finding the original, it broke on a layer line and I had to pick the pieces out, so fair warning.

Check out my other Anycubic i3 Mega accessories at: https://www.printables.com/social/55222-tyler/collections/95780

If this design is useful to you, consider a tip or post a make!

Print instructions

Print Settings

Printer Brand: AnycubicRafts: Doesn't MatterResolution: 0.1

Notes: Small hole may or may not need to be adjusted with a drill bit. It will depend on your printer/material. It should scale up or down if necessary.

If this design was useful to you, please post a make!