2024-10-20 06:00:08
5.8k
742
Bed Level Test Print for Kobra 3
@CRracer712_4733437
Donate
Message
Follow
Recommended printing method
Add
Bed Level Test Print for Kobra 3
Kobra 3
Kobra 2
、
Kobra S1
、
Kobra 2 Plus
、
Kobra 2 Neo
、
Kobra 2 Pro
、
Kobra 2 Max
、
Kobra 3 Max
、
Kobra 3 V2
、
Kobra X
/ Plates:1
/ 45m 25s
87
Share
Description
This is a simple bed level test print for the Kobra 3\Kobra 3 Combo. Prints to approximately 1 CM from edge of bed using less than 14 grams of filament. at a .2 mm layer thickness. You can resize the X and Y value only for a smaller print to test flow.
If your printed sheet looks good but has an occasional issue with adhesion here and there, you probably need to clean your plate (as shown in the red circle).
A lighter shade of filament is best to use for this test.
Tags
License
Standard Digital File License
This work is licensed under the Standard Digital File License.
You are prohibited from sharing, sub-licensing, selling, renting, hosting, transferring, or distributing the digital file or 3D printed versions of this object, as well as any other derivative work in either digital or physical form (including remixes).You are not allowed to use the objects in any manner that involves charging money or collecting fees without permission.
You are prohibited from sharing, sub-licensing, selling, renting, hosting, transferring, or distributing the digital file or 3D printed versions of this object, as well as any other derivative work in either digital or physical form (including remixes).You are not allowed to use the objects in any manner that involves charging money or collecting fees without permission.
Comments & Ratings
Here is empty
Remixes
