Bed skirt holder for Knaus caravans to stick on. The original holders are attached to the thin wooden board with very short screws that can withstand practically nothing. I have therefore enlarged the contact surface so that the holders can be glued on with a suitable adhesive. This now withstands considerably more load. I used UHU Allplast, although I'm sure other adhesives are also suitable.
The model has quite a few overhangs, as I wanted to retain the original mounting geometry as far as possible so that the clip mechanism works like the original. However, this made it quite difficult to remove the support structure. I therefore limited it to the bare essentials. As a result, the lower surface inside the two retaining spigots is somewhat unclean due to the unsupported overhangs.
