Brio Compatible 0-6-0 Tank Engine

This little shunter will happily pull around your Brio and Ikea trains.

Parts List:

• 6x M2 cap head screws 6-12mm length
• 6x M2 washers
• 2x 10x4x3mm ring magnets
• 2x 10mm diameter metal push pins
• A touch of CA glue

Printing Instructions:

1. Print 6 wheels, flat side down
2. Print one base piece, upside down orientation, some supports are required.
3. Print one each core and cover, some supports are required.

Assembly should be fairly straightforward.

• The wheels are each secured to the base with an M2 cap head screw, with a washer in-between the wheel and the base.
• The core sits in the slot in the base, with the smoke stack at the open end of the slot. A drop or two of CA glue holds them together. 
• Finally the cover piece slides on top. Be aware that any stringing will need to be removed prior to assembly. Again use CA glue to secure the parts. 
• The ring magnets go on the nubs on either end, and the tacks go in the holes to secure them in place.

If you like this model check out this collection of my other toy train models.