Cake Decorating Spinning Stand

This is a simple spinning base for a decorating cake stand!

The intention of the print is to attach it to the bottom of a food-safe plate or dish rather than placing food directly onto it.

Note that this print requires a 8mm x 22mm x 7mm (ID, OD, Thickness) bearing, which should be pretty standard to find (I bought a pack of these: https://www.amazon.com/dp/B0872ZT4JY?psc=1&ref=ppx_yo2ov_dt_b_product_details)

There are two sizes (120mm works for a 6" cake, 180mm for larger), and a few different versions of each.

Disclaimer: I've only printed the “min_120mm” to save filament and to test its weight capacity. “Half” and “Full” tops will likely be sturdier than the one I tested, which is still pretty sturdy for a 6" cake.