Centauri Carbon Large 2-Piece Waste Bin

I looked around at a few of the waste/poop buckets and didn't find what I was after. I also wanted one to come out the left so I can use it with a CANVAS enabled CC. Everything I looked at required a lot of supports, was a really long print, etc. There is another version of this which has a 1 piece bin and longer chute support, this is the 2 piece version that can be printed on bed sizes like the CC or Kobra 3 v2

This model requires minimal supports, and I'd recommend PETG or another filament other than PLA for the bucket so hot PLA is less likely to stick. That said, the bucket should print fine in PLA. I printed the sides in PLA and the bucket in PETG.

Once printed, snap the sides together, and attach using the existing two screws at the base of the chute on the back of the printer. Depending on your printer, choice of filament etc. you might want put a single drop of super-glue in the holes before snapping the sides together. Snap the two pieces of the bin together, a drop of super glue in each hole keeps them from vibrating free on the printer over time.