Centauri Carbon Waste Bin

I looked around at a few of the waste/poop buckets and didn't find what I was after. I also wanted one to come out the left so I can use it with a CANVAS enabled CC. Everything I looked at required a lot of supports, was a really long print, etc. There are two versions of this model, the first is the sides are 1-piece, and the bucket is one piece. I will be uploading a version that is split so smaller print beds can print it. The 1-piece requires a larger print bed such as a H2C, H2D, or any brand/flavor with that size bed or larger. The other profile, which I'm wrapping up will print on the smaller print beds like the CC, A1, PSx, etc.

This model requires no supports, and I'd recommend PETG or another filament other than PLA for the bucket so hot PLA is less likely to stick. That said, the bucket should print fine in PLA. I printed the sides in PLA and the bucket in PETG.

Once printed, snap the sides together, and attach using the existing two screws at the base of the chute on the back of the printer. Depending on your printer, choice of filament etc. you might want put a single drop of super-glue in the holes before snapping the sides together. I didn't need to as the H2D keeps a tight enough tolerance that it's snug.