Coaster / Beermat Holder

This is a fully 3D-printable remix of the excellent Coaster Holder by The Nostalgics.

The original design requires you to cut, sand, and finish a piece of real wood for the base. I loved the two-tone aesthetic but preferred to print all the components. I reverse-engineered the wooden base and designed this drop-in replacement, optimized specifically to be printed in Wood PLA! Of course, any other hard filament will work perfectly fine if you prefer.

The slots for the coasters are 90 mm wide and 4.5 mm thick.

Modifications

• Fully 3D Printable: Replaces the wooden base with a precise, ready-to-print part.
• Rubber Feet Recesses: Added four 9mm circular cutouts on the bottom to perfectly fit standard 8mm anti-slip rubber feet.

Print Settings & Recommendations

• Orientation: Print the bottom base right-side up, and print the top part upside down.
• Resolution: 0.2 mm
• Infill: 20 - 30%
• Supports: Yes

Assembly

1. Once printed, simply apply a few drops of superglue and press the two parts together.
2. Add four 8mm rubber feet into the 9mm bottom recesses to prevent slipping. (Optional)