0
0
:
0
0
:
0
0
:
0
0
Celebrate 11 Years with Anycubic: Capture Your 3D Printing Moments.
Makeronline
2026-11-15 00:20:31
48
2
Report

Confetti Cannon – Watch GIF! Rubber Band Powered

@MPdesign_5985240
Message
Follow
Recommended printing method
Description

A reusable confetti launcher with no springs, screws or special hardware. A piston is driven by two rubber bands, locked with a simple bayonet latch, and fires a burst of confetti with one twist. Load it, cock it, twist, and boom.

 

Assembly 

1. Slide the piston into the barrel from the open end. 

2. Push a pin through each side slot into the square socket in the piston. Make sure it sits fully in, then glue both pins in place with a drop of super glue. The pins must not pull out. 

3. Pass one rubber band through the eyelet on the barrel (loop it through itself), then hook the other end over the flange of the pin on the same side. Repeat on the other side. Two bands in total, one per side. 

 

How to use 

1. Pull both pins back along the slots (the bands stretch). 

2. Twist the pins sideways into the locking notch to hold the piston. 

3. Pour confetti into the barrel in front of the piston. 

4. Twist the pins back and the bands launch the piston, pushing the confetti out.

Tags
toy
party
confetti
launcher
cannon
wedding
celebration
new year
functional
print in place
License
Standard Digital File License
This work is licensed under the Standard Digital File License.
You are prohibited from sharing, sub-licensing, selling, renting, hosting, transferring, or distributing the digital file or 3D printed versions of this object, as well as any other derivative work in either digital or physical form (including remixes).You are not allowed to use the objects in any manner that involves charging money or collecting fees without permission.