Description
✨ Features
- 💡 LED strip integrated into the printer
- 🎛️ Control directly via the Kobra S1 display / slicer
- 🔌 No additional controller needed
- 🧼 Clean and minimal wiring
- ⚡ Uses existing power from the printer
🧰 Required Parts
- Any 24V LED strip (I have used this 4mm version)
- SS8550 PNP transistor
- 1 kΩ resistor
- Wires
📸 Included
- Before / after images
- Wiring instructions (what to solder)
- Circuit diagram
🔧 Installation
This mod requires basic soldering skills.
You will need to:
- Solder a connection to the control signal (from the LED output)
- Connect the LED strip to ground and
- Follow the provided wiring diagram
⚠️ Make sure to double-check polarity and connections before powering on.
⚠️ Disclaimer
- Perform this mod at your own risk
- Basic electronics knowledge is recommended
💡 Notes
- Works with standard 24 V LED strips (check voltage compatibility)
- Clean cable management is recommended for best results
Tags
License
Standard Digital File License
This work is licensed under the Standard Digital File License.
You are prohibited from sharing, sub-licensing, selling, renting, hosting, transferring, or distributing the digital file or 3D printed versions of this object, as well as any other derivative work in either digital or physical form (including remixes).You are not allowed to use the objects in any manner that involves charging money or collecting fees without permission.
You are prohibited from sharing, sub-licensing, selling, renting, hosting, transferring, or distributing the digital file or 3D printed versions of this object, as well as any other derivative work in either digital or physical form (including remixes).You are not allowed to use the objects in any manner that involves charging money or collecting fees without permission.

