CuisinartBeanExpansionBin

This is an expansion to the current coffee bean bin 'Cuisinart DGB-700HA Hopper Assembly' on DGB-900BC Cuisinart coffee maker, the one that holds the beans, grinds the beans and pours in the water.It allows adding a full lb of coffee beans to be stored in the coffee maker instead of under 1/2 lb. It raises the height of the coffeemaker but still fits under common cabinet heights in the USA.The existing lid is removed, this bin is pushed into the other coffee bean bin, and the lid is placed on this bin. The rubber seal is left where it is on the old bin. That seal will keep the expansion bin in place. If the bin doesn't exactly fit in the front (hint hint. it won't), then grind it down or heat the front bottom in a bowl of very very hot water. Then shove it into the old coffeemaker bin.I traced the existing bin on paper, scanned to a jpg, imported to cura, exported as stl, imported to Meshmixer, extruded and copied. Meshmixer would leave gaps between the rings. This was my first design. I had a lot of fun.I also added an automatic water filler but I'll publish that slightly later... (I can't remember where I got all the original parts from.)