Cute 3D Cat Monitor Clip立体猫猫屏幕夹

Cat Screen Clip. This clip is tightened with a knob on the back.Theoretically, no glue is required.However, if the back of your screen is not flat, use the version with a crossbar.If it still can’t stand steadily, apply some double-sided tape.After all, it’s a 3D design, haha.

Recently, I’ve updated the split-part version. The fit test for the cat face assembly works well.Important note: You must fully assemble the eyes first before fitting them in place. Otherwise, other parts will be hard to install.

It’s recommended to assemble by pushing upward from the bottom. Since the bottom part makes contact with the heated bed, it will be slightly wider than the top. The fit is snug enough in testing, so no glue is required for this part.

Glue is needed for the other components, especially the horizontal piece that clamps onto the edge of the monitor. The one-piece printed design actually fits better here, but I split it into separate parts to save material consumption.

猫咪屏幕夹，这款夹子后面有旋钮上紧。理论上不用胶水。但是你的屏幕后面如果不是平的就用那个有一个横条的版本。还是立不住的话就加点双面胶。毕竟咱是立体的嘛。哈哈。总之我没用横梁版本就夹住了。还挺可爱的。

最近更新了分件版本。猫脸测试安装还可以。但是要注意，一定要把眼睛组装完成再按进去。不然别的件不好安装。建议从下面往上推着装。因为下部与热床接触多少会比上部要宽一点点。测试还算紧实不用胶水也可以。

其他部件就需要胶水粘一下了。特别是扒住显示器边缘的横料。其实一体打印那个地方会更好。但是为了省料还是给拆了出来。