0
0
:
0
0
:
0
0
:
0
0
Celebrate 11 Years with Anycubic: Capture Your 3D Printing Moments.
Makeronline
2025-08-04 07:44:51
427
2
Report

Deck Post Tray for Bluetooth Speaker or Accessories

@sh4un_5828610
Message
Follow
Recommended printing method
Description

Deck Post Tray for Bluetooth Speaker or Accessories


I designed this tray to hold a Bluetooth speaker beneath a small TV mounted on my deck. It fits snugly onto a standard 3.5" x 3.5" (actual 90mm x 90mm) deck post. The tray surface measures 170mm x 170mm—perfect for small speakers, drinks, or other accessories.


The rear portion of the tray is open to accommodate a vertical post or conduit—ideal for setups where the deck post is up against a wall or used to support mounted devices like a TV or camera. While it was originally designed for my specific layout, the design is flexible and should work well in similar applications where rear clearance is needed.


There is a hole at the top to allow you to screw it to the post to make sure it's secure, and a cutout at the rear to run cables if needed.


Print Settings (Recommended):

  • Material: PETG or ASA for outdoor use (PLA may warp in sun)
  • Layer Height: 0.2mm
  • Infill: 20–30% (grid or gyroid)
  • Supports: Not needed
  • Walls/Perimeters: 3 or more for strength


Tags
Deck
Patio
Outdoors
Tray
Table
License