Dolce Gusto capsule dispenser

a quick and simple model to organize your capsules in your coffee corner

it holds up to 12 capsules, it works holding them by their corners against a wall

besides the model you can place some magnets (minimum 4 maximum 8 10x2 mm neodimium magnets) or some biadehesive thin strips along the four bumps besides the trays

until the dispenser is properly attached to a wall, it works flawlessly

printed at 0.2 layer height with no supports (just print it face down on the plate) and at least 3 bottom shell layers to prevent seeing the infill through the face, 2 top shells are enough instead

update 11/25/25: added a pre-split version for small printers which don't have a big plate, now it should fit on almost all of the beds out there!

be careful i cut with dove tail connections with 0.15mm tolerance, so if your printer is not well calibrated print with outer-inner wall order (to ensure better precision) and filing the edges may be necessary after the print

i added some smaller magnets area where the cuts were performed, to make the overall adehesion better (if you use magnets, if you use double-sided tape it should work seamlessly), care that you will need smaller magnets for those slots, they should be 6x2 mm to fit properly