DragonBall HueForge

Ho realizzato questa stampa in onore di uno dei miei manga preferiti, di seguito le istruzioni per stamparla con o senza AMS.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA BambuLab Basic Red Transmission Distance: 5

PLA PolyTerra Savannah Yellow Transmission Distance: 3.5

PLA PolyTerra Sunrise Orange Transmission Distance: 2

PLA+ Sunlu White Transmission Distance: 5

Swap Instructions:

Start with Black

At layer #7 (0.64mm) swap to Blue Gray

At layer #9 (0.8mm) swap to Red

At layer #11 (0.96mm) swap to Savannah Yellow

At layer #12 (1.04mm) swap to Sunrise Orange

At layer #15 (1.28mm) swap to White for the rest.