Enclosure track for poop chute

model comes in 3 parts, the base, chute and top. recommend lining the inside with aluminum tape if printing at high temp to keep the poop from sticking. designed to work with my revised butthole design here: https://www.makeronline.com/en/model/Kobra%203%20butthole%20v2%20for%20enclosure%20build/23777.html

will likely work with others as long as the width of the back ramp is under 40mm. can tack the track together with a little glue to keep it aligned where is needed. base will need support. others should be fine without it if printed in the correct profile. adding aluminum tape to the inside where the poop will touch the surface will help prevent sticking and smooth operation. i would recommend adding something to keep the printer from drifting around if you have a poop chute that protrudes into the channel. i made https://www.makeronline.com/model/Kobra%203%20Feet%20Cleats%20v1/21103.html for that very reason, to keep the printer static but still allowing the vibration dampeners of the feet to work