Ergonomic Door Handle for Anycubic Kobra S1

This is a redesigned door handle for the Anycubic Kobra S1, created to improve both ergonomics and appearance compared to the stock solution,

I wanted a handle that feels better to use while also matching a clean, minimal design language.

Why this handle?

• Larger and more comfortable grip
• Cleaner, more intentional shape
• Designed to look like a factory part, not an add-on

Features

• Ergonomic grip
• Minimalist, Prusa inspired design
• Uses original mounting holes and screws
• Print friendly geometry (no supports needed)

Compatability

• Anycubic Kobra S1 (specifically the front foor)

Printing Notes

• Material: PLA, PETG or ABS
• Layer height: 0.12-0.20 mm
• Perimeters: 3
• Infill: 100%
• Print orientation: flat on the bed
• Supports: Not required

Installation

Remove the original handle and install this one using the existing mounting points. No additional hardware required.

If you have suggestions or ideas for omprovements, feel free to leave a comment or upload a make. Feedback is always welcome! :D