Filament Sensor inside ACE Pro

I printed these with a .25 Nozzle on a Flash Forge 5m Pro (only printer loaded with PETG. But the .4 Nozzle on my S1 Kobra sliced this just fine with a .12mm Standard height. You do need to enable tree supports with Organic type but these fall off VERY EASY! Be very careful due to their SMALL SIZE, but if you have lost of damaged your filament sensor in the ACE Pro then these are a suitable replacement AND THEY WORK! I have tested these on a broken ACE Pro. You will also need to source the compression spring. This set had 20 of them for $4.99 plus 370 other springs. Pair these with this print and your wear items on your Ace are a thing of the PAST!

I would recommend printing these in PETG, ASA, or ABS due the ACE Pro also drying filament at 55 degrees Celsius (131 Fahrenheit).

Amazon Link - https://www.amazon.com/dp/B0F47T44GH?ref=ppx_yo2ov_dt_b_fed_asin_title