Fixed Blade 1

Knife Two! no folding here just a good old fixed blade using a standard box cutter blade.

another one inspired by the awesome designs @maker209  put out. be sure to check theirs out!

Hardware Requirements:

You’ll need 9 total machine screws, either 3x4mm or 3x5mm, depending on your preference:

• 3 screws for the case
• 3x4 or 5mm machine screws
• 6 screws for the handle / scales you have a choice….
• I used 3x4 machine screws so it looks nice. there is also ones that do not have a chamfer so you can use hex cap screws if you hate things looking nice and feeling smooth.
• 3 more 3x5mm screw for the clip

About the Clip (full transparency):

Quick heads up… I’m pretty bad at making clips….This one’s a little rough around the edges, but it works!! I’ll clean it up and update it sooner or later.

The clip uses:

• Three 3x5 hex screws