Flexible Snake PLA + TPU Customizable

This is a snake model I designed, that uses two different materials, but doesn't need an expensive toolchanger printer. Because it prints in seperate pieces, you can use as many different colors as you want.

Print directions: 

Snake-Tpu:

Print in TPU filament, no supports. The size that worked for me was .62mm tall, but you may need to adjust depending on your printer's tolerances.

All other parts:

Print in PLA, no supports. About 23 pieces.

Assembly:

Starting with the head, slide it on to the TPU, then continue down adding the rest of the pieces with however much spacing you desire, until you reach the end.