Hueforge Alien Zombie

Project: HFAlien150.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 150x150mm in size

 You may print at higher layer heights below the Min Depth of 0.48mm

 The Max Depth is 2.1mm and the Actual Depth is 2.1mm

Filaments Used:

PLA PolyLite Black Transmission Distance: 0.3

PLA BambuLab Basic Jade White Transmission Distance: 5

PLA BambuLab Basic Silver Transmission Distance: 0.6

PLA BambuLab Basic Red Transmission Distance: 4

This print uses 4 unique filaments

Swap Instructions:

Start with Black

At layer #7 (0.64mm) swap to Jade White

At layer #14 (1.2mm) swap to Silver

At layer #16 (1.36mm) swap to Red

WARNING: This Slider is at the same Layer as the Next Slider

At layer #25 (2.08mm) swap to Jade White for the rest.