KALLAX MMU Filament System

Donate

Message

Recommended printing method

Print Profile Files (0)

Raw Model Files (12)

+ Frequently Used Printer

459.07KB

57.50KB

62.00KB

More profile

Description

Spool holders use 608 bearings
Use an M8 screw 32cm approx. measure your setup
Spool holders use M3 heat inserts to attach feet, as suggested on the start, middle, and end pieces
Foots use an M3 screw
Drill templates to attach spool holders (start and end ones) to KALLAX walls
Umbilical top use M3 heart inserts
Umbilical bottom use magnets 10x5 with M4 hole (https://amzn.eu/d/eJPtjzp)
Umbilical filament joiner use magnets 10x5 with M4 hole, assure attraction with umbilical bottom ones, and ECAS04 to handle PTFE tubes
Umbilical filament joiner visualizer to be printed by filament type/color to identify it
Skadis PTFE Guide/Retainer uses M3 screws and heat inserts
Umbilical Table version uses magnets 10x5 with M4 holes