Kobra 3 Printhead (Back piece)

Recommendation

<= 0.2 mm layer height

lay flat orientation

use high temp material such as abs pc or other

use the original screw from the orignal print head

use support blocker to prevent the support to go into screw hole

Message from DuckDoCad

do this at your own risk

part may have measurement mistake

feel free to remix but pls give credit

**This is not official stl** the orignal part is better than this

Have fun yayyy

Link for the Printhead front piece

https://www.makeronline.com/en/model/Kobra%203%20Printhead%20(%20Front%20piece)/32046.html