Kobra S1 Nozzle Wiper (compatible with Bambu Lab Build Plate Adapter)
The Kobra S1 can take advantage of Bambu Lab build plates for the X1/P-series since the bed is roughly the same size. There is a model on Maker Online that allows quick alignment of Bambu Lab build plates:
https://www.makeronline.com/en/model/Kobra%20s1%20Bambu%20build%20plate%20aligner/168695.html
I wanted the BQ CryoGrip Glacier plate, but BQ hasn't released a model specific to the Kobra S1. With the build plate aligner, it simplifies using Bambu Lab-compatible build plates and makes them convenient.
This model works very well and is compatible with the stock PTFE nozzle wiper for the Kobra S1. If you want to upgrade the nozzle wiper, they additional width prevents the use of the Bambu Lab build plate aligner. This model allows you to use the silicone brushes that are cheap and readily available for the A1 Mini by biasing the brushes to be center and left of the nozzle wiper. The build plate aligner can move to its topmost position without colliding with this model wiper.
This prints in 15 minutes or less and has "pockets" deep enough where the standard adhesive for the silicone brush is good enough to allow rigorous, thorough wiping.
The model leverages the A1 Mini silicone brush - which has a base that is deeper than the one for the A1. You'll want to cut the brush to make a 4mm long section (4 brush rows deep).
