Kobra S1 Right Side Poop Shoot & Basket

*Tip - rub a little cooking oil or vegetable on the shoot an slide to prevent filament sticking

V2 added which is 10mm winder, larger opening at top exposing the printers exit shoot allowing larger poop to slide through and 3 degree more slope giving it about 14mm downwards angle

With version 2 being lower you’ll either have to print the anti vibration feet I made as well

or

cut the original basket

or

print a new basket and descale it 25mm less taller then original in the slicer

I looked everywhere and without luck i couldn't find a right sided poop shoot and basket for my kobra S1, two days work this is the result.

The shoot/slide only needs support ON THE BOTTOM NOT THE TOP where it has double screws, the 3 locations where it screws to the printer uses factory screws so no extras are needed in the mounting.

This will fit on the Anycubic Kobra S1 so no need to run to a larger printer.

Use support blockers on the top of the shoot and play with your support for the bottom to get it to fit on the s1 build plate in the slicer

all parts will fit as it was designed for the s1 print bed