Kobra S1 bed tramming spacers

• Iv had bed level issues from the start. iv worked on it for about a week and again anycubic doesn't really incorporate any sort of bed tramming and there wiki is very lack luster.
• i made sure my z axis is level but my bed is still about 1mm off in the back while the front would be touching my nozzle so i made different length spacers to help with that difference. i use the smallest 9mm length one and ended up putting a m4 washer with the spacer to raise the bed in the back.

• Quick tip: if you notice there's a dip in the middle of the back of your bed there are 3 screws under the bed that will most likely correspond with that dip. loosen the and just tighten till you feel slight resistance.

• I made these spacers out of TPU 95A

1 wall, 10% gyroid infill

feel free to make them how you like they are quick and easy to print!