LED Medieval Torch

Behold, an extremely cheap way to bring your decorations to the next level.

All you need is a three-pack of Dollar Tree LED tealight candles.

I also have a wall mount available at: Wall Mount for Medieval Torch - Makeronline - More Than Fun

I printed it with a 0.2mm layer height and 5% infill. The Torch_jar was printed using the spiral vase mode with 3 bottom layers and zero top layers.

This model was designed to fit onto light saber handles, but will fit onto a dowel rod as long as it's 30mm.  I can change the size of the hole to fit different sizes as requested. I have also included a handle.

Assembly is fairly simple:

Step 1: glue one of the sides to the base.

Step 2: glue the first ring onto the side, lining it up with the lowest bump.

Step 3: Glue on the second ring, lining it up with the other bump.

Step 4: glue on a second side opposite the first. 

Step 5: glue on the other two sides.

Step 6: turn on the three tealights and place them inside the torch.

Step 7: insert the jar, bottom up, into the torch.

Slide the handle in and your done!