Lavazza Firma Pod Size Calibration Tool

Are you planning to design or print your own custom coffee pod holders for Lavazza Firma capsules? Don’t waste time and filament—use this Capsule Gauge to ensure your design is a perfect fit before you start your big print!

This is part of the COFFEE STATION COLLECTION

This "fit tester" is a simple, precise tool designed to help you verify the dimensions of your Lavazza Firma pods. It acts as a reference gauge so you can check tolerances and ensure your capsules slide in and out of your future holders with the perfect amount of clearance.

✨ Key Features:

• Precision Fit: Specifically engineered for the dimensions of the Lavazza Firma capsule system.
• Prototyping Tool: A must-have for makers creating custom coffee station accessories.
• Compact & Efficient: Prints in just a few minutes with minimal material.

🛠️ 3D Printing Settings:

• Material: PLA is recommended for this calibration tool to ensure dimensional accuracy.
• Layer Height: 0.2mm (or lower for higher precision).
• Infill: 5%
• Important: Make sure to print this with your standard settings to verify the fit accurately.

This gauge will help you dial in your settings before printing a large 40-pod tray, here is the LINK.

If you prefer, you can print the Capsule organizer Prototype also in order to check the large 40-pod tray.