Mini Water Cooler Can Cousy (Victoria Secrets edition)

This profile is ready to print no supports required !!! Just upload and print. Please make sure your build plate is clean. I use glue sticks just for added security of nothing going wrong within the first couple layers. I set the first 2 layer speed very low only bc i was printing the lid on a smooth holographic plate. if your using the same type of plate for the shiny effect for the lid i suggest you leave the first layer speeds as i have them if not feel free to set them to your preference but i wouldnt go above 50mm/s. This is set up for printing in PLA + filaments and was printed in my KobraS1. I have a brim set for the pink parts that are smaller to gain a better foot print hold to the buildplate.