Nuka Cola Clock - Fan Art

This fan art clock is great for any game room. With a silver bottle cap look this clock is sure to impress any fan of the game.

NO AMS REQURED! Just filament swap at the different layers to get the colors you want. There is a pre-colored AMS file also attached. Check out my full profile for more clocks and fun 3D Prints!

This does require supports and I suggest using a .3 air gap for the underneath. The supports will stay on the print bed when you pull it off. I also set my supports .5 away from the model. Traditional supports with a wider pattern, I used a 8mm wide pattern which was a good balance and removed very easily. The goal is just to prevent major sagging when bridging the bottom layer. Use a fine .16 layer height for nice results.

You do need to purchase a clock movement, they run about $10 and can get one at any craft store or big box store. Amazon has a great selection. The one I used specifically for this one was https://amzn.to/47QD3q7 . Amazon referral link I have no affiliation with the manufacturer.

When it comes to hardware, I rely heavily on Bambu Lab 3D printers. My A1 Mini https://rb.gy/uofj5 is a staple in my office, while my fleet of X1C Carbons https://rb.gy/9r2az ensures rapid and high-quality production. #ComissionsEarned which help support my free model development.