Overhead camera mount

Overhead camera mount.

Tired of shaky footage? Awkward angles that are never just right? Well, no more of that!

With this model, you can make your very own Overhead camera mount. It has adjustments in all the dimensions needed: up, down, left, right, up, down... It even rotates around itself! Is that not enough? Ok, well, the phone holder also rotates, so you can get the perfect angle for your videos.

This uses a 25 mm aluminum pipe. I used 1-meter sections for both the vertical and horizontal axes. Then you can use some TPU sheets to put in between the screws and the pipe (or some rubber sheets or anything grippy would work too). These might be optional, depending on what kind of use you have for this and how long you make the horizontal pipe.

The assembly should be relatively simple. When you print this, make sure you have enough walls and infill on the parts, especially the cross mount, table clamp, and the screws.