PTO now functional for the TEA20 MK3 OpenRC Tractor. You may exchange the fake PTO and use this prepared adapter to have a functional PTO, driving mills, saw, hammer, seeder, lifts etc.
Using a micro servo MG90 or SG90.
Remove the housing, put the gear parts in stock for later use and unsolder the potentiometer from the pcb. Clean the solder joints and put two smt resistors with fixed value between 2kOhms and 5kOhms as the photo shows, take care for the assembly height.
Both resistors must have the same value, here you see 2,2kOhms.
Now you can connect the 360degrees servo to your control and choose a middle rudder position.
check the temperature of the motor fet, as it is getting hot, when the motor is not proper assembled. this happens often with the cheap China servos. if it's getting hot, change the motor to another spare.
Just touch the FET with your tip finger, if it stays cool during turning activity, it's done.
Press on the axle cap by heating up the tooth gear using a very fine solder tip at 400degrees, tipping through the hole, while pressing the plastic centered onto the gear.
You will see the gear molded with its teeth in the cap.
Now the motor can turn analog to your stick position forward an backward. if the spinning frequency is too hight, you can use the same motor with gear set.
Because there is no modification needed at the tractor, it is easily to attach with two screws M2.5mmx30mm or 2.5mmx25mm ( depends on your position of screw nut )
You are prohibited from sharing, sub-licensing, selling, renting, hosting, transferring, or distributing the digital file or 3D printed versions of this object, as well as any other derivative work in either digital or physical form (including remixes).You are not allowed to use the objects in any manner that involves charging money or collecting fees without permission.
