Passthrough Traffic Cone Fidget V2

Hello!

First of all I would like to thank everyone for your kind support on the first version!

Make sure to check me out on MakerWorld for print profiles for bambulab printers:

https://makerworld.com/en/models/643841#profileId-569889

Due to popular demand I decided to make V2 which is more suitable for children.

The edges are now softer and the model is redesigned to make it a bit more realistic.

The main concern with the original one was the top “spikes", they are now cut down and smooth so children cant get hurt!

I recommend printing the 200% version for children since they can't swallow the little parts.

Provided you can also find the smaller 100% version as well as some other profiles which will fit your needs.

This model doesnt require an AMS to print, the same as the last one.

This is done by manualy changing the filament type after each stop, I added a print profile with all the stops allready implemented, you just have to change the filament :)

You would have to do that for a total of 5 times: Start with black filament, after which orange, after which white, then orange,white and in the end orange again!

Print settings:

200% version:

• 0.2mm layer height
• 2 walls
• 15% infill
• for AMS version use Black, Orange and White PLA

100% version:

• 0.16mm layer height
• 2 walls
• 15% infill
• for AMS version use Black, Orange and White PLA