Pikachu urban Hueforge

Project: pikachu.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 224.22x400mm in size

 You may print at higher layer heights below the Base Thickness of 0.48mm

 The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm

Filaments Used:

#080a0d PLA PolyLite Black Transmission Distance: 0.3

#4c5f71 PLA BambuLab Basic Blue Gray Transmission Distance: 3

#0056b8 PLA BambuLab Basic Cobalt Blue Transmission Distance: 1.2

#c00d1e PLA BambuLab Basic Red Transmission Distance: 4

#fec600 PLA BambuLab Basic Sunflower Yellow Transmission Distance: 4.4

#e2dedb PLA PolyLite White Transmission Distance: 5

This print uses 6 unique filaments

Swap Instructions:

Start with Black

At layer #8 (0.72mm) swap to Blue Gray

At layer #9 (0.8mm) swap to Cobalt Blue

At layer #12 (1.04mm) swap to Red

At layer #17 (1.44mm) swap to Sunflower Yellow

At layer #21 (1.76mm) swap to White

Border Only Colors from here until the end.

At layer #28 (2.32mm) swap to Red for the rest.