Pirate playset: patch - coin - hook - (foam)sword

Ahoy, matey! Ready to sail the seven seas looking for treasure? Whether you're gearing up for Halloween, a costume party, or just some epic backyard roleplay, this ultimate pirate playset has everything your little captain (or you!) needs to live the pirate life.

This set includes:

• Pirate hook: with an easy screw mechanism connecting the hook to a handle, hidden under the cover.
• Pirate coin: a detailed supportless printing coin with a skull on it.
• You can print this coin 360° design (standing up) or with a flat back to glue together later - the last one prints considerably faster for giant treasure piles.
• Eyepatch: just add elastic thread through the holes
• This eyepatch is has 2 variants: with and without a pirate logo
• The eyepatch is printed upwards to avoid print scarring, therefor I just pained my logo white to save filament
• Sable: printed in 2 pieces, just push the blade in the handle.
• The point of the sword is dulled down, for obvious reasons.
• Foam sword: screw the handle into a piece of pool noodle to make your own (very safe) pirate sword.
• This was designed for a pool noodle of 6 cm diameter and a hole of 1,5 cm.

The items are big enough so an adult can wear them as well. Allthough the fully 3D printed sable is more a big fancy (but very cool) dagger (about 35 cm tall).

I testprinted the hook at 75% and the screw system works perfectly, but that would be more for a toddler (max 5 years). Everything older I suggest the 100% version.

Assembly

Hook

Hold the hook part into place and screw in the bottom handle part, with the cover in between.

Foamsword

Screw in the handle into the pool noodle part.

I used a pool noodle of diameter 6 cm and a a hole opening of 1,5 cm.

The part I used was cut at 50 cm tall.

Sable

Push the sword part into the handle part, add a dab of glue in the opening. It is a tight fit, but it will need a bit of glue.

I wish you all many fun battles and treasure hunts!