RVJet air/speed brakes

Top and bottom airbrakes for the RVJet to be used with the Curved hood scoops for the RVjet. I designed the parts to use a Spektrun A7010 slim wing servos. Other servos may fit but have not been tested. You will also need 1 of the solid carbon rods that came with the RVJet that are used to hold the wing on, for the top airbrake. And some 2 mm carbon rod for the hinges on the bottom airbrakes. The top airbrake will need to be assembled and secured with CA or an epoxy. The bottom airbrakes will fit into the bottom of the pockets where the hood scoops are located. Print 2 of these one for each side. You will cut enough foam for the bottom front piece to mount up tight against the carbon tube support for the wing, then epoxy it in so the hood scoop sits flush on top. Once the bottom airbrakes are installed then cut just enough foam for the bottom trim piece to fit around the airbrake. Video of it working can be found here: https://www.youtube.com/watch?v=V7xeao8JAJ0