Salt and Pepper Holder

Salt and Pepper Holder

Description

It is designed to hold Salt and Pepper grinders. It keeps all the accidental button presses contained while being easy to move from a shelf to the dining room table for meals.

Pros

• Minimalistic
• Strong
• Easy usage

Printing Notes

I would use PETG for this print for strength instead of PLA. If you have good PETG settings it shouldn't be too hard but if not it will warp. I used 5 walls for extra strength but depending on how heavy your salt and pepper grinders are you might not need as many but I wouldn't drop it below 3 walls. Make sure that it is dried properly because on the tall section there could be a lot of stringing. If you have any problems please leave them in the comments.