Santa Round Lantern

Description

Warning!! This takes patience to put together.

Santa Round Christmas Lantern with 3 thin layers that fit into a base. The layers have tabs on the bottom that fit into the slits on the base. The front layer with Santa is printed in two parts, you will need to put those two layers together to make one.

The layers are printed very thin at 0.2mm. Be careful when taking them off the heat bed. Slide the tabs on the end into the slits on the opposite end.

You can size up or down. For best results size up.

3 Layers to print and 1 base.

A tea light will sit in the middle.

You need patience when putting this together.