Sliding clicky pills box

A simple sliding pill box with four compartments and a mechanism that opens one compartment at a time and locks it in place.

I did my best to calibrate the tolerances, but the final fit may vary depending on the printer, material, and print settings. You may need to lightly sand the outer flat surfaces of the inner piece.

If you do, make sure to remove all dust and residue before use.

Material safety notice

This design is provided as a 3D-printable model only. The designer does not manufacture, supply, test, or certify the printed object or the materials used to produce it.

Material composition and suitability may vary depending on the filament manufacturer, additives, colorants, printer, nozzle, printing conditions, and post-processing. Users are responsible for selecting a material suitable for their intended use and for verifying any applicable safety or regulatory requirements.

Medicines should preferably remain in their original blister packaging. Direct contact between loose medication and a 3D-printed surface is not recommended unless the finished object and material have been specifically assessed and certified for that purpose.

If you appreciate my work and want to support me, you can buy me a coffee